Home > Support > Knowledge Base
Knowledge Base
 
Reset Search
Search
 

 

Knowledge

Optimizing USB to serial port settings

« Go Back

Information

 
Problem Resolution
Digi interface boards and USB adapters use an FTDI Chip for the USB to serial conversion. The default configuration for FTDI's drivers are optimized for high speed serial devices. Digi RF radios operate at lower baud rates than are optimal for these drivers and can cause some communication problems when performing certain tasks. Performing a firmware recovery or firmware update may fail unless the driver settings are modified.

The following procedure will show you how to reduce the USB transfer sizes and latency timing. While these instructions are specifically for USB devices that use FTDI Chip components, it's likely that similar options would be present on other USB to Serial adapters that are also experiencing communication problems.

 


Procedure

This guide assumes you have a Digi USB interface board (XBIB-U, XIB-U, XTIB-U) plugged into the computer and that the appropriate drivers have been installed.

1. Go to the Windows Device Manager

a. Click on the Start / Windows button
b. Find My Computer (Windows XP, 2000) or Computer (Windows 7, Vista)
c. Right-Click on My Computer / Computer
d. Select Manage

Computer Management

2. Select Device Manager from the left-hand column

Device Manager

3. Find the Port (COM & LPT) section in the right-hand column and expand it
4. Find and Right-Click on the USB Serial Port (this can be named a number of things, make sure it is the correct one for your radio)
5. Select Properties

Properties

6. Click on the Port Settings tab
7. Click on Advanced

Properties Window

Change the following:

8a. Receive (Bytes): from 4096 to 64
8b. Transmit (Bytes): from 4096 to 64
9. Latency Timer (msec):  Change this to 1

Advanced section

10. Click OK on both windows and close the Device Manager. The driver is now optimized for use with Digi radios.

If the radio you are working with appears to be unresponsive even after performing the above steps, you may need to perform a recovery. Please use the following link to go to our comprehensive recovery guide:

Recovery procedure for Digi RF products

Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255