Home > Support > Knowledge Base
Knowledge Base
 
Reset Search
Search
 

 

Knowledge

Example application using the XPress Ethernet multipoint bridge

« Go Back

Information

 
Problem Resolution

An industrial automation company uses Digi's Multipoint XPress Ethernet Bridges (XEBs) for SCADA (Supervisory Control And Data Acquisition).

Rockwell Automation's market-standard Allen-Bradley Ethernet PLCs are connected to data/control points in an industrial plant (see figure above). Up to 16 PLCs are connected to Digi's Multipoint XEBs, which act as a wireless network switch to connect the PLCs back to a central PC. The PC runs Rockwell RSLinx software for monitoring flow, controlling pumps, and opening/closing valves.

This application utilizes the Industrial (Outdoor) version of the Multipoint XEB, which features a NEMA-4 enclosure and an operating temperature of -40 °C to 70 °C. A protected, on-board DIP Switch allows the user to configure each Multipoint XEB as an Access Point (base) or Subscriber Unit (remote). Radios can be configured in minutes without having to use a PC.

The Multipoint XEB operates in the 900 MHz license-free ISM band of the U.S. and Canada. It boasts a range of up to 1000 feet without RF line-of-sight and up to 15 miles (with high-gain antenna) for RF line-of-sight applications. Networks are secured with 128-bit encryption.

Digi is pleased to report successful internal testing with the following PLCs:

  • 1756 ControlLogix
  • 1763 MicroLogix 1100
  • 1747 SLC5/05
  • 1761 ENI
  • DigiOne IAP
Results are shown in the figure below

Note: The XEB does not perform IGMP snooping, which limits propagation of ODVA I/O multicast packets. If this is required it can be performed by the external switch linking the XEB into the network.


Feedback

 

Was this article helpful?


   

Feedback

Please tell us how we can make this article more useful.

Characters Remaining: 255