> Knowledge Base
How do I recover my Digi ConnectPort X4?
Recovery Procedure for Digi Connect (Wi) SP
Collecting General Technical Support Logs for Digi Connect WAN and Digi ConnectPort WAN Cellular Devices
Recovery procedure for XBees
Recovery procedure for ZigBee XBees
Collecting Technical Support Logs for Digi Connect WAN and Digi ConnectPort WAN Cellular Devices with Provisioning Issues
The Digi CM, Digi Passport, and ConnectPort LTS disaster recovery procedure.
HOW TO: Troubleshoot Device Cloud Connectivity Issues from the WebUI of a Digi Connect WAN or ConnectPort gateway
How to recover a Digi Connect (Wi-)ME (9210), (Wi-)EM and (Wi-)SP JTAG'less C module
Recovery procedure for XTend
What would you like to know?
< Back to search results
Digi Connect Wan Recovery Procedure
Recovery Procedure for Digi Connect Wan Family (non 3G)
Locate the 4 service pins recessed in the housing just to the left side of the Ethernet connector. Apply a standard jumper to the 2 pins closest to the Ethernet port.
Connect a cross-over serial cable to the Console port and bring-up a terminal emulator program and set it to 9600 8 n 1 (for CLI access)
Power-on the device and wait for the POST menu
Select "t" from the boot menu for TFTP related choices
Select "2" from the TFTP options menu
Enter TFTP file name of the firmware ( ie 82001160_G.bin )
Enter IP address for the unit ( ie 192.168.1.1 )
Enter Network Mask ( ie 255.255.255.0 )
Enter Network Gateway ( ie 192.168.1.1 )
Enter TFTP Server address ( ie 192.168.1.100 )
Enter "3" to get file from TFTP server
Enter "4" to put TFTP'd OS into flash
Enter "v" to valid flash
Enter "5" to run OS from flash
You should get a command prompt.
Power down unit and remove jumper
Power unit back up and it should come up running on the recently flashed firmware/OS
Was this article helpful?
Please tell us how we can make this article more useful.
© Copyright 1996 - 2015 Digi International Inc. All rights reserved. Your M2M Expert®